Broan CBX1 Serie Manual De Instrucciones
Ocultar thumbs Ver también para CBX1 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

CBX1 Series
Range Hoods
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufac-
turer. If you have questions, contact the manufacturer at the
address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the ser-
vice disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service
panel.
3. Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction.
4. Sufficient air is needed for proper combustion and exhaust-
ing of gases through the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society of Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code au-
thorities.
5. This product may have sharp edges. Be careful to avoid cuts
and abrasions during installation and cleaning.
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. Use only metal ductwork.
9. Do not use this fan with any solid-state speed control device.
10. As an alternative, this product may be installed with the UL-
approved cord kit designated for the product, following in-
structions packed with the cord kit.
11. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may ig-
nite. Heat oils slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when
flambéing food (i.e. Crepes Suzette, Cherries Jubilee, Pep-
percorn Beef Flambé).
3. Clean ventilating fans frequently. Grease should not be al-
lowed to accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for
the size of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet,
or metal tray, then turn off the burner. BE CAREFUL TO
PREVENT BURNS. If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE DEPARTMENT.
Register your product online
at: www.broan.com
FOR DOMESTIC COOKING ONLY
WARNING
2. NEVER PICK UP A FLAMING PAN — You may be burned or
spread the fire.
3. DO NOT USE WATER, including wet dishcloths or towels - a
violent steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher, and you
already know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Firesafety Tips" published by NFPA.
CAUTION
1. For indoor use only.
2. For general ventilating use only. Do not use to exhaust haz-
ardous or explosive materials and vapors.
3. To avoid motor bearing damage and noisy and/or unbal-
anced impeller, keep drywall spray, construction dust, etc.,
off power unit.
4. Do not use over cooking equipment greater than 60,000
BTU/hr.
5. Your hood motor has a thermal overload which will automati-
cally shut off the motor if it becomes overheated. The motor
will restart when it cools down. If the motor continues to shut
off and restart, have the hood serviced.
6. A maximum height of 24" above the cooktop is recommend-
ed for best capture of cooking impurities. The bottom of the
hood MUST NOT BE LESS than 18" above the cooktop.
7. Please read specification label on product for further infor-
mation and requirements.
NOTE
If hood is to be installed non-ducted:
Purchase non-ducted filter (Model BPQTF) from your
local distributor or retailer.
Installer: Leave this manual
with the homeowner.
Homeowner: Cleaning, Maintenance and
Operating instructions on page 2.
CBX1 SERIES
Page 1

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Broan CBX1 Serie

  • Página 1 CBX1 SERIES Page 1 CBX1 Series Register your product online at: www.broan.com Range Hoods READ AND SAVE THESE INSTRUCTIONS FOR DOMESTIC COOKING ONLY WARNING WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN- 2. NEVER PICK UP A FLAMING PAN — You may be burned or JURY TO PERSONS, OBSERVE THE FOLLOWING: spread the fire.
  • Página 2: Cleaning & Maintenance

    CBX1 SERIES Page 2 OPERATION LIGHT BULBS The light bulbs included with this hood are the latest in LED cooktop illumination technology - offering bright lighting and Always turn the hood ON before cooking in order to establish an air flow in the kitchen. After turning off the range, let the hood run lasting up to 10 times as long as a normal bulb.
  • Página 3: Install Ductwork

    CBX1 SERIES Page 3 INSTALL DUCTWORK PREPARE HOOD LOCATION (Ducted Hoods Only) Use the proper diagram below for placement of ductwork and electrical cutout in cabinet or wall. For a non-ducted installation, DO NOT cut a duct access hole. ROOF CAP 3¼"...
  • Página 4: Prepare The Hood

    CBX1 SERIES Page 4 CONTENTS 7” ROUND * FIND INSIDE DUCT OF HOOD PLATE (1) 3¼” X 10” (1) 7” ROUND (1) GREASE DAMPER / DUCT DUCT FILTER CONNECTOR* CONNECTOR (1) PARTS BAG** CONTAINING: (5) #10 X 5/8” RD. HD. Remove 7”...
  • Página 5: Install The Hood

    CBX1 SERIES Page 5 INSTALL THE HOOD 7” ROUND KNOCKOUT PLATE (also WARNING remove 3¼” x 10” To reduce the risk of electrical shock, switch power off vertical plate) at service panel. Lock or tag service panel to prevent power from being switched on accidentally. 3¼”...
  • Página 6: Connect The Wiring

    CBX1 SERIES Page 6 CONNECT THE WIRING GROUND SCREW HOUSE POWER CABLE Connect House Power Cable to range hood wiring - BLACK to BLACK, WHITE to WHITE, and GREEN or BARE WIRE to Ground Screw. Re-connect lamp wire harness and re-attach bottom panel with (8) screws as shown in Step 9.
  • Página 7: Service Parts

    CBX1 SERIES Page 7 SERVICE PARTS DESCRIPTION PART NO. BOTTOM PANEL, STAINLESS STEEL (includes hardware) 97018653 SCREW PACKAGE FOR BOTTOM PANEL & AIR DUCT R602534 #8-18 X 3/8 (10 REQ.) (2 SCREWS IN BAG) LAMP WIRE HARNESS 99271468 MOTOR WIRE HARNESS (includes power harness) 97019363 LED LIGHT (2 REQ.) (includes hardware) 97019364...
  • Página 8 Limited Warranty Warranty Period and Exclusions: Broan-NuTone LLC (the “Company”) warrants to the original consumer purchaser of its product (“you”) that the product (the “Product”) will be free from material defects in the Product or its workmanship for a period of one (1) year from the date of original purchase.
  • Página 9 SERIE CBX1 Página 9 Campanas Registre su producto en el Serie CBX1 sitio web www.broan.com LEA Y CONSERVE ESTAS INSTRUCCIONES SOLAMENTE PARA COCINAR EN CASA ADVERTENCIA ADVERTENCIA PARA REDUCIR EL RIESGO DE LESIONES A LAS PERSONAS EN CASO DE PARA REDUCIR EL RIESGO DE INCENDIO, DESCARGA ELÉCTRICA...
  • Página 10: Funcionamiento

    SERIE CBX1 Página 10 FUNCIONAMIENTO LIMPIEZA Y MANTENIMIENTO ENCIENDA siempre la campana antes de comenzar a cocinar, con el fin de El mantenimiento correcto de la campana de la estufa asegurará el establecer un flujo de aire en la cocina. Después de apagar la estufa, deje funcionamiento adecuado de la unidad.
  • Página 11: Prepare El Lugar Donde Se Va A Instalar La Campana

    SERIE CBX1 Página 11 INSTALE EL SISTEMA CONDUCTO VERTICAL DE TORNILLOS DE MONTAJE 3¼ X 10 PULG. (8.3 X 25.4 CM) DE CONDUCTOS (Sólo campanas DE LA CAMPANA (5) para sistemas con conductos) 13-15/16 pulg. (35.4 cm) 13-15/16 pulg. (35.4 cm) (campana de 30 pulg./76.2 cm) (campana de 30 pulg./76.2 cm) FRENTE DEL GABINETE...
  • Página 12: Prepare La Campana

    SERIE CBX1 Página 12 CONTENIDO PLACA DEL CONDUCTO * ENCUENTRA EN EL INTERIOR REDONDO DE LA CAMPANA. DE 7 PULG. (17.8 CM) CONECTOR CONECTOR PARA REGULADOR/ PARA CONDUCTO (1) FILTRO CONDUCTO DE 3¼ X 10 REDONDO DE DE GRASA PULG. (8.3 X 25.4 CM)* 7 PULG.
  • Página 13: Instale La Campana

    SERIE CBX1 Página 13 INSTALE LA CAMPANA PLACA REDONDA DE ORIFICIO CIEGO DE 7 PULG. (17.8 CM) (TAMBIÉN DESMONTE LA PLACA ADVERTENCIA VERTICAL DE 3¼ X 10 PULG. Para reducir el riesgo de una descarga eléctrica, [8.3 X 25.4 CM]) desconecte el suministro eléctrico en el panel de servicio.
  • Página 14: Conecte El Cableado

    SERIE CBX1 Página 14 CONECTE EL CABLEADO TORNILLO DE TIERRA CABLE ELÉCTRICO DE LA CASA Conecte el cable eléctrico de la casa al cableado de la campana: cable NEGRO con NEGRO, BLANCO con BLANCO y VERDE o SIN FORRO al tornillo de tierra. Reconecte el arnés de cables de la lámpara y vuelva a conectar el panel inferior con ocho (8) tornillos, como se muestra en el paso 9.
  • Página 15: Piezas De Servicio

    SERIE CBX1 Página 15 PIEZAS DE SERVICIO CLAVE DESCRIPCION NO. PARTE PANEL INFERIOR, ACERO INOXIDABLE (incluye piezas) 97018653 PAQUETE DE TORNILLOS PARA PANEL INFERIOR Y DUCTO DE AIRE R602534 # 8-18 x 3/8 (10 req.) (2 tornillos en bolsa) ARNES DE CABLES DE LAMPARA 99271468 ARNES DE CABLES DE MOTOR (incluye cables de alimentación) 97019363...
  • Página 16: Garantía

    Garantía limitada Periodo y exclusiones de la garantía: Broan-NuTone LLC (la “Compañía”) garantiza al consumidor comprador original de su producto (“usted”) que el producto (el “Producto”) estará libre de defectos en materiales o en mano de obra, por un periodo de un (1) año a partir de la fecha de compra original.

Tabla de contenido