Broan CJD1 Series Instrucciones De Instalación página 5

PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical & for 7" Round
Discharge)
REAR RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
Remove appropriate Duct Knockout(s) from top or back of
11
hood.
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
Discharge)
PREPARE THE HOOD
UP TO 1"
SIDE-TO-SIDE ADJUSTMENT
3¼" x 10" Ducted Discharge Only: Remove Tape from damper
12
flap and attach Damper/Duct Connector over knockout
opening with screws removed in Step 4 under "PREPARE
THE HOOD" . Make sure damper Pivot is nearest to Top/Back
Edge of hood.
13 7" Round Ducted Discharge Only: Re-install 7" Round Duct
Plate removed in Step #1 under "PREPARE THE HOOD" .
Install a 7" round damper (#97010792 - purchase separately).
Damper flap must open freely in direction of airflow (away from
range hood).
To accomodate off-center ductwork, the Damper/Duct
NOTE
Connector can be installed up to 1-inch on either side of
hood center or the 7" Round Duct Plate can be installed
up to ½" on either side of hood center. In extreme off-center
installations, one end of the duct connector may need to be trimmed
to clear the electrical cable clamp.
CJD1 SERIES
Page 5
TAPE
DAMPER/
DUCT
CONNECTOR
(Vertical
discharge
position
shown)
PIVOT
TOP/BACK
EDGE