Troubleshooting; Before Calling For Service - LG LP1213GXR Manual Del Usuario

BEFORE CALLING FOR SERVICE

Before you call for service, review this list. It may save you time and expense. This list includes
common occurrences that are not the result of a defect in workmanship or materials.
The air conditioner is
Air
unplugged.
conditioner
does not
The fuse is blown/circuit
start
breaker is tripped.
Power failure.
The current interrupter
device is tripped.
FL appears in the display.
Room temperature is less
than the set temperature.
Airflow is restricted.
Air conditioner
does not cool
as it should
The temp control may not
be set correctly.
The air filter is dirty.
The room may have been
hot.
Air conditioner The cooling coils are iced
freezing up over.
Area to be cooled is too
Air conditioner
large for the air conditioner.
runs too often
or too long
Doors or windows are open.
T R O U B L E S H O O T I N G
Make sure the air conditioner plug is pushed
completely into the outlet.
Check the house fuse/circuit breaker box and
replace the fuse or reset the breaker.
If power failure occurs, turn the mode control
to Off. When power is restored, wait 3 minutes
to restart the air conditioner to prevent tripping
of the compressor overload.
Press the RESET button located on the power
cord plug. If the RESET button will not stay
engaged, discontinue use of the air conditioner
and contact a qualified service technician.
The water collection tank is full. Drain the tank
and reset your settings.
This is normal. The air conditioner automatically
shuts off when the room equals or is less than
the set temperature. Adjust the temperature
setting, if needed.
Make sure there are no curtains, blinds, or
furniture blocking the front of the air conditioner.
In COOL model，press the DECREASE pad.
Clean the filter at least every 2 weeks.
See the Care and Cleaning section.
When the air conditioner is first turned on, you
need to allow time for the room to cool down.
Ice may block the air flow and obstruct the air
conditioner from properly cooling the room.
Set the mode control at High Fan or High Cool.
Consult your dealer for the air conditioner
capacity necessary to cool the desired area.
Make sure doors and windows are closed.
23