Ryobi RAP200 Manual Del Operador página 8

WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
TOOLS NEEDED
Adjustable wrench (2), 2 mm hex key
INSTALLING THE WHEELS
See Figure 3, page 16.
To attach the wheels to the base:
 Locate the axle assembly.
 Slip the axle into the wheel hole. Slide small washer onto
axle.
 Lifting the paint station slightly, slide the axle, wheel, and
small washer into the wheel mounting hole in the machine
base.
 Slide large washer onto the axle.
 Push the hitch pin into the hole on the end of the axle to
secure assembly.
 Repeat with the second wheel assembly.
FOLDING THE HANDLE
See Figures 4, page 16.
 To raise the handle: pull the handle up until the handle
release knob snaps through the locking hole to secure
the handle in place.
 To lower the handle (for storing): pull the handle release
knob on the right side of handle and lower.
WARNING:
Never use the handle to lift the paint sprayer. Failure
to heed this warning could result in serious personal
injury.
ASSEMBLy
cONNEcTING HIGH PRESSURE HOSE/PISTOL-
GRIP SPRAyER
See Figure 5, page 16.
To connect the high pressure hose to the paint station:
 Screw the collar on the high pressure hose onto the spray
hose outlet located on the pump.
 Tighten securely with an adjustable wrench.
To connect the pistol-grip sprayer to the high pressure
hose:
 Screw the collar on the high pressure hose onto the
pistol-grip sprayer by turning the hose collar clockwise.
 Use an adjustable wrench to hold the nut on the pistol-
grip sprayer and another to turn and tighten the nut on
hose end and tighten securely.
INSTALLING REVERSABLE SPRAy TIP AND
NOzzLE TIP GUARD ON PISTOL-GRIP
SPRAyER
See Figure 6, page 16.
See operator's instructions for flushing, priming and cleaning
before installing nozzle tip guard and spray tip. Note all
warnings regarding use of pistol-grip sprayer and the
possibility of injection.
 Turn lock-off thumbscrew counterclockwise to lock
sprayer trigger.
 Install nozzle seat and cap into nozzle tip guard.
 Thread nozzle tip guard assembly onto sprayer and tighten
securely.
 Select spray tip and push securely into nozzle tip
guard.
 Keep pistol-grip sprayer trigger locked when not in use.
INSTALLING PAINT ROLLER
See Figure 7, page 16.
 Place roller caps in each end of the paint roller.
 Align pins in the end of each roller cap to the holes inside
the roller head. Push out on the side of the roller head
until the roller snaps into place.
8 — English