Receiving the stored
stations
1
Press (SOURCE) repeatedly to select the
radio.
2
Press (MODE) repeatedly to select the
band.
3
Press the number button ((1) to (6)) on
which the desired station is stored.
Tip
Press either side of (DISC/PRESET) to receive the
stations in the order they are stored in the memory
(Preset Search function).
If preset tuning does not work
Press either side of (SEEK) to search for
the station (automatic tuning).
Scanning stops when the unit receives a
station. Repeat until the desired station is
received.
Tips
• If automatic tuning stops too frequently, turn on
the Local Seek to limit seek to stations with
stronger signals (see "Changing the sound and
display settings," page 18).
• If you know the frequency of the station you
want to listen to, press and hold either side of
(SEEK) to locate the approximate frequency,
then press (SEEK) repeatedly to fine adjust to
the desired frequency (manual tuning).
If FM stereo reception is poor
Select monaural reception mode.
(see "Changing the sound and display
settings," page 18).
The sound improves, but becomes
monaural ("ST" disappears).
Note
If interference occurs, this unit will automatically
narrow the reception frequency to eliminate noise
(IF AUTO function). In such cases, some FM stereo
broadcasts may become monaural while in the
stereo reception mode.
Tip
To always hear FM stereo broadcasts in stereo, you
can change the IF AUTO setting and widen the
frequency signal reception (see "Changing the
sound and display settings," page 18). Note that
some interference may occur in this setting.
14
Storing only the desired
stations
You can manually preset the desired stations
on any chosen number button.
1
Press (SOURCE) repeatedly to select the
radio.
2
Press (MODE) repeatedly to select the
band.
3
Press either side of (SEEK) to tune in the
station that you want to store.
4
Press the desired number button ((1) to
(6)) for 2 seconds until "MEM" appears.
The number button indication appears in
the display.
Note
If you try to store another station on the same
number button, the previously stored station will
be erased.