Development And Sales - STOP&GO 6 PLUS-MINUS SKT Instrucciones De Instalación

Ocultar thumbs

Contenido

página de 32

/ 32
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Prior to

Function

Installation

installation

check

After installing the control device, laying the high-voltage cable and attaching the stainless steel contact plates, the

setup should be retested to ensure that it functions correctly. Perform the test using a standard multimeter. Set "direct

current – 300 V" and measure the voltage between the two stainless steel contact plates (should read 250–300 V). If the

function check is successful but voltage fails to build up after installation, an installation error has occurred.

The red diode confirms that the ultrasonic speaker is functioning. The yellow LEDs confirm that high voltage has built up.

Blinking at regular intervals (approx. every 5 seconds) = OK: ultrasound is being emitted, high voltage has built up.

Fast blinking = voltage is building up/dissipating. Caution: residual voltage!

LED off = device is switched off.

Prior to

Function

Installation

installation

check

Is the operating voltage (12 V plus and minus) of the car battery also present at the unit connections?

Is the engine switched off?

Does the cable to terminal 15 have any voltage? (Is the ignition switched on? If so, the device will be switched off.)

Have all the plus stainless steel contact plates (marked with a yellow sticker) been installed so that they

do not touch any other live or earthed parts (risk of short circuit)?

Has the position of the stainless steel contact plates on the cable been changed, damaging the copper core?

No voltage detected on the stainless steel contact plate: Have the stainless steel contact plates been firmly

pressed into the base?

Is the bonnet contact switch active and is this function available?

Prior to

Function

Installation

installation

check

Bonnet contact switch*

12 V (+)

Terminal 15

12 V (–) earth

Fuse box

Control device

STOP&GO

*Installing the bonnet contact switch

The bracket is fixed in such a way that the bonnet activates the pressure pin of the bonnet contact switch, i.e. so that the electric circuit is interrupted

when the bonnet is opened.

Trouble

Circuit

Warranty

shooting

diagram

Trouble

Circuit

Warranty

shooting

diagram

Trouble

Circuit

Warranty

shooting

diagram

0.5 A F

Function control lights

"click" instead of screw

Plus plate (marked with a sticker)

Minus plate

STOP&GO

Base

Fastening eyes/tunnel

Prior to

Function

Trouble

Installation

installation

check

shooting

IMPORTANT! Terms of the warranty (please keep in a safe place)!

Our 6 PLUS-MINUS SKT High-voltage device with ultrasound comes with a 48-month functional warranty.

Any reasonable complaints within the warranty period from the date of purchase will be remedied free of charge,

either through repair or delivery of a replacement product at our discretion. In order for the warranty to apply,

our product must have been properly installed and maintained in accordance with our installation instructions.

To enable us respond to problems, please return the complete unit, including the cable, stainless steel contact

plates, bonnet contact switch and installation invoice, initially at your own expense.

Installation and removal costs will only be covered by us in the event that the device is proven to be defective.

Any claim under Section 5 of our General Terms and Conditions shall remain unaffected, subject to the condi-

tions set out therein.

Any damage caused by improper installation or incorrect, negligent or forceful operation shall invalidate the

warranty. There shall be no liability for consequential damage.

Technical changes and errors excepted.

Please fill in to claim against the warranty: For warranty claims to be processed, you must send us the filled in coupon

and the garage/installation invoice!

Garage stamp

Date of purchase

Technical support hotline

+49 (0) 7631 9727-80