Settings; Tool Holder, Attachments; Working With The Machine - Festool T18+3 Manual De Instrucciones

8

Settings

CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
8.1 Changing direction of rotation [1-6]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
8.2 Changing gear [1-8]
Only actuate the gear switch with the tool
switched off. Otherwise there is a risk of
damaging the gear unit.
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
8.3 Fastening
Adjust the switch so that its marking [1-11]
faces the screw symbol [1-10].
Adjust the torque accordingly at the torque
wheel [1-12].
Position 1 = low torque
Position 25 = high torque
An acoustic signal sounds when the preset tor­
que is reached and the machine then switches
off. You must release and press the ON/OFF
switch [1-5] again to start the machine.
8.4 Drilling
Adjust the switch [1-11] so that its marking
faces the drilling symbol [1-9]. Maximum tor­
que is set in this position.
9

Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
9.1 CENTROTEC tool chuck [3]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN­
TROTEC tool chucks.
9.2 Chuck BF-FX
For clamping drill bits and bits with max. shaft
diameter of 13 mm.
Clamp tool centrally in the chuck.
9.3 Angle attachment DD-AS [5]
Drilling and screwing at right angle to machine
(partly as an accessory).
9.4 Eccentric attachment DD-ES [6]
Screwdriving near edges with bits according to
ISO 1173 (partly as accessory).
9.5 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.

10 Working with the machine

WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
10.1 Bit depot [1-4]
Magnetic, for storing bits and bit holders.
10.2 Acoustic warning signals
Acoustic warning signals sound and the ma­
chine switches off in the following operating
states:
Battery flat or machine over­
loaded.
–
–
Machine is overheating.
–
LiIon battery pack is faulty or
has overheated.
–
Change the battery.
Place the machine under
reduced stress.
You must allow the ma­
chine to cool beforeusing
again.
Once the battery pack has
cooled, perform a func­
tional check using the
charger.
English
15