Settings; Tool Holder, Attachments; Working With The Machine - Festool C 18 Li Manual De Instrucciones

Recommendation: Charge the battery pack
*
before any further use.
Further information about the battery pack
and charger can be found in the corre­
sponding operating manual.
8

Settings

CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
8.1 Changing direction of rotation [1-8]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
8.2 Changing gear [1-4]
Only actuate the gear switch with the tool
switched off. Otherwise there is a risk of
damaging the gear unit.
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
8.3 Fastening
Adjust the switch so that its marking [1-7]
faces the screw symbol [1-6].
Adjust the torque accordingly at the torque
wheel [1-1].
Position 1 = low torque
Position 25 = high torque
An acoustic signal sounds when the preset tor­
que is reached and the machine then switches
off. You must release and press the ON/OFF
switch [1-9] again to start the machine.
8.4 Drilling
Adjust the switch [1-7] so that its marking
faces the drilling symbol [1-5]. Maximum tor­
que is set in this position.
9

Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
< 15%
*
CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
9.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN­
TROTEC tool chucks.
9.2 Chuck BF-FX
For clamping drill bits and bits with max. shaft
diameter of 13 mm.
Clamp tool centrally in the chuck.
9.3 Angle attachment DD-AS [6]
Drilling and screwing at right angle to machine
(partly as an accessory).
9.4 Eccentric attachment DD-ES [7]
Screwdriving near edges with bits according to
ISO 1173 (partly as accessory).
9.5 Tool holder in the drill spindle [8]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.

10 Working with the machine

WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
10.1 Bit depot [1-2]
Magnetic, for storing bits and bit holders.
10.2 Acoustic warning signals
Acoustic warning signals sound and the ma­
chine switches off in the following operating
states:
English
15