Walgreens WGNBPA-230 Manual De Instrucciones página 11

Display Symbols:
User 1: Appears when the monitor is operated by User 1.
User 2: Appears when the monitor is operated by User 2.
Low Battery Symbol: Appears when batteries should be replaced,
or +/- polarities have been positioned incorrectly.
Pulse Symbol: Shows the heart rate per minute.
Irregular Heartbeat Detector: See page 22 for more information.
Risk Category Index: See page 21 for more information.
Memory Average: Displays average of last 3 readings.
START
STOP
AM/PM Average: Indicates the reading being displayed is an
average from the last 3 mornings or last 3 evening measurements.
START
STOP Excessive Body Motion Detector: Appears when excessive body
movement, especially of the arm the cuff is worn, is detected during the
measurement. See page 23 for more information.
NOTE: The measured blood pressure reading may not be accurate
if the icon is displayed. Properly wrapping the arm cuff is important. If the
circumference of the upper arm differs largely from the circumference of
the forearm, an excessive gap may occur between the arm and the
arm cuff, and result in the false detection of excessive body motion.
Check-with-Confidence™: Appears upon first use and then every 30th
use, during the self-check function. See page 18 for more information.
If and any of the following letters and numbers appear in the area that
systolic pressure should be displayed, an error has occurred with your reading. See
Troubleshooting section of this manual for more information.
Measurement Error: Wrap the cuff correctly and keep arm steady
during measurement. Measure again.
Air Circuit Abnormality: Check cuff connection. Measure again.
Pressure Exceeding 300 mmHg: Turn the unit off to clear, then
measure again.
Error Determining Measurement Data: Wrap the cuff properly,
keep steady, and measure again.
System Error: Turn off monitor and measure again. If "EP" still appears
on the display, please call a Consumer Relations representative.
10