Allmatic XTILUS Importantes Instrucciones De Seguridad Para La Instalación página 10

FIXING OF THE REAR PLATE TO THE COLUMN
Fix the rear plate to the column (Fig. 4) in accordance to the desired coordinates.
In case an iron pillar is available, screw directly onto the column the plate with
3 screws M8..
In case you need to fix the bracket onto a concrete pillar, use the fixing plate to
be fastened with 3 Fischer screws of Ø 8 mm.
When the backing plate is fixed, anchor the rear part of the piston to the plate
and fasten it firmly (Fig. 6).
ATTENTION: when establishing the height off the ground at which to fasten
the plate to the pillar (Fig. 4), keep in mind that the plate for anchoring
the piston to the gate must be fastened 40 mm below that on the post to
obtain horizontal levelling (Fig. 5).
Motor
FIXING OF THE FRONT PLATE TO THE GATE
For the fixing of the front plate to the leaf, follow this procedure:
1. Fit the anchor plate onto the piston. Insert the washer, tighten the bolt
firmly (Fig. 7).
ATTENTION: lubricate the hole of the front plate and the towing of the
motor with silicone grease before the fixing.
2. Close the gate.
3. Move the piston with the plate already fitted towards the gate.
4. Move the stem to the limit stop, then move it back by approximately 1 cm
and mark the position of the plate.
5. Realize the same operation in opening.
6. If positions correspond, fix the plate on the gate; otherwise revise A and B
coordinates (TABLE 1).
N.B.: during the installation, try several times to open and to close the gate,
controlling that the gearmotor does not touch the moving gate
ADJUSTMENT OF MECHANICAL LIMIT SWITCH - OPTIONAL
The gearmotor may be provided with mechanical limit switches, optional, in
opening and/or closing, if the gate is not fitted with a floor stop (Fig. 8).
To adjust, slacken the screws on the limit switch and move it to the desired
position. Lock the screws (Fig. 9).
FINAL CHECK OF THE INSTALLATION
Before to proceed with the electrical cabling of the motor, check the correct
movement of the gate:
1. Unlock the motor and move manually the wing of the gate.
2. If the wing moves easily, the installation is correct. Otherwise lubricate the
hinges, the hole in the front plate and the towing of the gate. Check the
correct installation of the motor.
MAINTENANCE
To be carried out exclusively by skilled persons after the power supply to
the motor has been interrupted.
Lubricate the hinges, the hole of the front plate, the towing of the motor and
check the thrust force generated by the gearmotor on the gate once a year.
Lubricate the nut screw with silicone grease every two years.
10/20
ATTENTIONE: use a level
PIN
for the positioning of the
Plate
Seeger
FIG. 6
ITA ENG
Front plate
plates.
FRA ESP DEU POR
Rear plate
TIGHTEN
FIRMLY
6-1624846 rev.14
FIG. 4
FIG. 5
FIG. 7
FIG. 8
FIG. 9
23/03/2016