Installing Your Canopy Housing - Fanimation CELANO v2 FP8062B Serie Manual De Instrucciones

4. Once the connection has been made, slide the
receiver into the hanger bracket, taking care not to
pinch the wires. (Figure 5)
NOTE: This step is applicable after the neccessary wiring
is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
How to Wire Your Ceiling Fan (continued)

Installing Your Canopy Housing

WARNING
Hanger Bracket
12
Receiver
Figure 5
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2