Husqvarna 536LiP4 Manual De Instrucciones página 14

WARNING! Always remove the battery to
!
prevent the machine being started by
accident. Make sure that the cutting
attachment has stopped completely
before you start to do any work on the
machine.
Specification of bar and saw chain
When the cutting attachment supplied with your machine
has to be replaced, because it is worn out or damaged,
you must only fit the types of bar and saw chain
recommended by us.
Guide bar
• Length (inches/cm)
• Chain pitch (inches). The spacing between the drive
links of the chain must match the spacing of the teeth
on the bar tip sprocket and drive sprocket.
• Number of drive links. The number of drive links is
determined by the length of the bar, the chain pitch
and the number of teeth on the bar tip sprocket.
• Bar groove width (inches/mm). The groove in the bar
must match the width of the chain drive links.
14 – English
GENERAL SAFETY PRECAUTIONS
• Lubrication hole and hole for the chain tensioner.
Saw chain
• Saw chain pitch (inches). (The distance between
three drive links, divided by two.)
• Drive link width (mm/inches)
• Number of drive links.
Level of kickback reduction. The only thing that describes
the level of kickback reduction offered by a saw chain is its
model number.
Sharpening your chain and adjusting
raker clearance
WARNING! The risk of kickback is
!
increased with a badly sharpened chain!
General information on sharpening cutting teeth
Li-ion Li-ion
• Never use a blunt chain. When the chain is blunt you
have to exert more pressure to force the bar through