Panel Description; Turning On The Power; Front Panel - Icom IC-F29DR2 Manual De Instrucciones

1

PANEL DESCRIPTION

■ Turning ON the power

NOTE: For optimum life and operation, the battery must be
fully charged before using the transceiver for the first time.
Rotate [VOL] to turn ON the power.

■ Front panel

Antenna
[Rotary Selector]
[PTT]
Microphone
[Upper]*
[Lower]*
* Other functions can be
assigned to these keys
with the CS-F29DR2
programming software
(purchase separately).
5
D About the Speaker microphone jack
The transceiver meets IP67 requirements for dust-tight
and waterproof protection only when the jack cover or
the optional HM-168LWP, HS-94LWP, or HS-95LWP is
attached.
D About the LED Indicator
• Lights red while transmitting.
• Lights green while receiving a signal.
• You should charge the battery when the indicator slowly
[VOL]
blinks green.
• You must charge the battery when the indicator blinks
green fast.
[Top]*
D Factory default key assignment
[Upper]
LED indicator
[Lower]
Speaker-
Microphone
[Top]
jack
Speaker
* CTCSS tone or DTCS code
z Push to make a Smart-Ring call.
z Hold down to make a Call-Ring call.
L See the next page for more detail.
Hold down to release the C.Tone* mute. The
mute is released even if the received signal does
not include a matching C.Tone*.
z Push to select Zone 1, Zone 2, Zone 3, or Zone 4.
z Hold down to turn the Channel Announce
function ON or OFF.
NOTE: The Zone number is announced when
selecting a Zone, regardless of the Channel
Announce setting.