Error Handling; About Indicators - Sony VPL-VZ1000 Manual De Referencia Rápida

Error Handling

About Indicators

The WARNING1 or WARNING2 indicator lights up or flashes if there is any trouble with your projector.
If there is any problem or an error message appears on the screen, refer to "Error Handling" in the Operating Instructions
contained in the supplied CD-ROM.
Flashing/Lighting indicators
(Flashes in red)
Both indicators flash
(Flashes in red)
(Flashes in red)
Note
If the indicator starts flashing in a way of other than the above, or the symptom persists even after carrying out the above methods, consult with
qualified Sony personnel.
14
GB
Error Handling
WARNING1
The number of Cause and Remedy
flashes
Three times The light source does not light properly due to an abnormality of the light source or
light source power. Turn off, then turn on the power after a while.
If the symptom persists, consult qualified Sony personnel.
Six times The unit detects a drop impact.
If there is abnormality on the unit, consult with qualified Sony personnel.
If there are no abnormalities on the unit, disconnect the AC power cord and check
that the LED indicator turns off, then connect the AC power cord and turn the unit
on.
Twice The internal temperature is unusually high. Check to ensure that nothing is blocking
the ventilation holes, the air filter is not clogged, and the unit is not being used at
high altitudes.
Three times The fan is broken. Consult with qualified Sony personnel.
WARNING2