Instruction Manual - Makita DTD155 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Fastening capacities
No load speed
Impacts per minute
Rated voltage
Overall length
Battery cartridge
Charger
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Intended use
The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841:
Sound pressure level (L
Sound power level (L ) : 105 dB (A)
WA
Uncertainty (K) : 3 dB(A)
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841:
Work mode: impact tightening of fasteners of the maxi-
mum capacity of the tool
Vibration emission (a ) : 14.0 m/s
h
Uncertainty (K) : 2.0 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
Machine screw
Standard bolt
High tensile bolt
Hard impact mode
Soft impact mode
Hard impact mode
Soft impact mode
) : 94 dB(A)
pA
2
2
BL1815, BL1815N, BL1820, BL1820B, BL1830, BL1830B,
BL1840, BL1840B, BL1850, BL1850B, BL1860B
DC18RC, DC18RD, DC18SD, DC18SE, DC18SF
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
SAFETY WARNINGS
General power tool safety warnings
WARNING:
Read all safety warnings, instruc-
tions, illustrations and specifications provided
with this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/or
serious injury.
4 ENGLISH
DTD155
4 mm - 8 mm
5 mm - 14 mm
5 mm - 12 mm
-1
0 - 3,000 min
-1
0 - 1,300 min
-1
0 - 3,900 min
-1
0 - 1,600 min
D.C. 18 V
135 mm
1.2 - 1.5 kg