Bar And Chain Combinations - Ryobi P548 Manual Del Operador

MAINTAINING THE GUIDE BAR
When the guide bar shows signs of wear, reverse
it on the saw to distribute the wear for maximum
bar life. The bar should be cleaned every day of
use and checked for wear and damage.
Feathering or burring of the bar rails is a normal
process of bar wear. Such faults should be
smoothed with a file as soon as they occur.
A bar with any of the following faults should be
replaced.
 Wear inside the bar rails which permits the chain
to lay over sideways.
 Bent guide bar.
 Cracked or broken rails.
 Spread rails.
Lubricate guide bars with a sprocket at their tip
weekly. Using a grease syringe, lubricate weekly in
the lubricating hole. Turn the guide bar and check
that the lubrication holes and chain groove are free
from impurities.
NOTE: Do not replace the screw with an ordinary
screw. Use only identical replacement parts from
the manufacturer when replacing parts.
Chain specifications: 3/8 in. pitch, low profile narrow kerf, .043 in. chain gauge, 5-tooth drive sprocket.
Length of Bar
12 in.
MAINTENANCE

BAR AND CHAIN COMBINATIONS

Guide Bar Part Number
312637001
TRANSPORTING AND STORING
See Figure 46.
 Do not store or transport the chain saw when
it is running. The chain saw should always be
idle before storing or transporting.
 Always place the guide bar scabbard on the
bar and chain before storing or transporting the
chain saw. Use caution to avoid the sharp teeth
of the chain.
 Clean the chain saw thoroughly before storing.
Store the chain saw indoors, in a dry place that
is locked and/or inaccessible to children.
 Keep away from corrosive agents such as gar-
den chemicals and de-icing salts.
Chain Part Number
32 - English
682117001
Fig. 46
Drive Links
45