Installing The Unit; When Moving This Unit - Pioneer X-SMC55-S Guia De Inicio Rapido

Sistema micro slim
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10

Installing the unit

When installing this unit, make sure to put it on a level and stable surface.
Don't install it on the following places:
– on a color TV (the screen may distort)
– near a cassette deck (or close to a device that gives off a magnetic fi eld).
This may interfere with the sound.
– in direct sunlight
– in damp or wet areas
– in extremely hot or cold areas
– in places where there is vibration or other movement
– in places that are very dusty in places that have hot fumes or oils (such as a kitchen)
Please always refer to the attached operating instructions (CD-ROM) included with
the unit when hanging the unit on the wall.
Connecting a playback component
Connect the FM wire antenna into the FM
antenna socket.
5 V
2.1 A
PHONES
AUDIO IN
LAN(10/100)
ANTENNA
DC IN
18 V
Connecting your iPod/iPhone to
the iPod/iPhone dock
1 Press the PUSH OPEN panel.
PU SH OP
EN
Push
2 Connect your iPod/iPhone.
Dock connector
Lock release switch
When closing the iPod/iPhone
dock
When closing the dock, slide the lock
release switch once to the left. This will
release the lock on the dock, so return the
dock to the original position.
RELEASE
CAUTION
Do not connect the iPad/iPad mini to
the dock. The unit is not compatible.
Do not connect any device that is not
compatible. The iPad/iPad mini may fall
and cause injury, or tilt over and cause
damage to the device (especially around
the connector section).
Connecting antennas
Using external antenna
To improve FM reception, use a PAL
connector (not supplied) to connect an
external FM as shown below.
Connecting your iPod/iPhone/iPad
(via a USB terminal)
or USB device
Connect your iPod/iPhone/iPad or USB
device to the USB terminal on the side panel.
USB cable provided with iPod/iPhone/iPad units, or
a commercially available USB cable to support iPod/
iPhone/iPad (for iPod connection)
After you've fi nished making all connections, plug the unit into an AC outlet.
AC adapter
(Supplied)
To AC outlet
Power cord (Supplied)

When moving this unit

When moving the unit, be sure to fi rst check
that there is no disc loaded and disconnect the
iPod/iPhone/iPad. Then press  STANDBY/
ON, wait for "STAND BY" disappears on main
display to turn off, then unplug the power cord.
Damage may occur if the unit is transported or
moved with a disc inserted, or when another
device is connected to the iPod/iPhone dock,
USB terminal, or AUDIO IN mini-plug jack.
Connecting using LAN cable
LAN cable
(commercially
One-touch
available)
5 V
2.1 A
PAL connector
PHONES
AUDIO IN
LAN(10/100)
ANTENNA
75 coaxial
cable
DC IN
18 V
USB storage device
(commercially
available)
Connecting using wireless LAN
5 V
2.1 A
PHONES
AUDIO IN
LAN(10/100)
ANTENNA
DC IN
18 V
Plugging in
1 Plug the supplied AC adapter into the DC
IN socket on the side of the unit.
2 Plug the supplied power cord into the AC
adapter then plug the other end into an AC
outlet.
Internet
Modem
Router
LAN
3
2
1
WAN
Computer 1
Computer 2
5 V
2.1 A
PHONES
AUDIO IN
LAN(10/100)
ANTENNA
DC IN
18 V
Internet
Modem
Router
LAN
3
2
1
WAN
Computer
This unit
3
En

Publicidad

Tabla de contenido
loading

Tabla de contenido