Installation
WARNING
• To prevent fire, do not use plastic, thin-foil, or non-metal flexible ducts of any kind.
• Do not use a poor exhaust system because it slows down the dryer's performance.
• Do not use excessively long ducts that have multiple elbows.
• Do not use crushed or clogged venting or ducts.
Switching the door position
26
English
DV8700K-03170T-01_EN (US).indd 26
To reverse the direction of the door, we
recommend that you contact a qualified
technician.
It is recommended to put a soft rug on the
floor to prevent scratches on the door.
1. Unplug the power cord of the dryer.
2. Remove the four hinge screws from
the door, and then remove the door by
lifting it up slightly.
3. Remove the two screws from the lever
holder, and then remove the holder
cover.
4. Put the lever holder on the other side
as shown, and then tighten the screws.
Install the holder cover on the opposite
side as shown.
2015-12-08
1:05:05