The Position Of Thread Guide Bar; Attaching The Spool Holder Cap And Net - Janome 9102D Manual De Instrucciones

2
1, 2
1
1
2
14

The Position of Thread Guide Bar

1
1. Pull the thread guide bar up as far as it will go.
2. Turn the thread guide bar so that the thread
3
4
*

Attaching the Spool Holder Cap and Net

3
1. When you use a small thread spool, pull out the
4
2
2. If the thread slips down from the spool during
*
2
1
guides are right above the spool pins.
1
Thread guide bar
2
Thread guide
3
Stoppers
4
Spool pin
Make sure to lock the thread guide of guide pole
in the correct position with the two stoppers.
spool holder from the spool pin. Then place the
spool with its slit side up, and put the spool holder
cap on top of it.
1
Spool holder
2
Spool pin
3
Spool holder cap
4
Slit
threading and/or sewing, put a net on the spool as
illustrated to prevent jamming.
The spool holder cap and net are optional
accessories.
1
Net
2
Spool pin