The Position Of Thread Guide Bar; Attaching The Spool Holder Cap And Net - Janome MY LOCK 744D Libro De Instrucciones

Janome 744D Instruction Manual
w
1, 2
q
1
q
2
www.toews.com
16
q
e
r
e
r
w
w

The Position of Thread Guide Bar

1. Pull the thread guide bar up as far as it will go.
2. Turn the thread guide bar so that the thread
guides are right above the spool pins.
q
Thread guide bar
w
Thread guide
e
Stoppers
r
Spool pin
* Make sure the two stoppers on the thread guide
shaft, as shown, are set in at the correct position.

Attaching the Spool Holder Cap and Net

1. When you use a small thread spool, pull out the
spool holder from the spool pin. Then place the
spool with its slit side up, and put the spool
holder cap on top of it.
q
Spool holder
w
Spool pin
e
Spool holder cap
r
Slit
2. If the thread slips down from the spool
during threading and/or sewing, put a net on the
spool as illustrated to prevent jamming.
q
Net
w
Spool pin
744D Owners Manual/ User Guide
Janome Serger 744D