Broan EPLEC1 Serie Manual De Instalación, Uso Y Cuidado página 10

Ocultar thumbs Ver también para EPLEC1 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4 ] Remove the screw holding the 3¼" x 10" adapter/damper as well as the one for the 3¼" x 14"
5 ] Remove both tape strips holding the 7" round adapter, and put the adapter aside.
6 ] Remove the parts bag taped in the lower left corner of the hood.
7 ] Using a 11/32" nut driver or socket, remove the lock nut retaining the flange of the right
NOTE: For 30 in.-wide hoods, slightly lift up the cover plate before sliding it towards the left to
10
adapter/damper, remove their tape strips and and put the adapter/dampers aside. Save these
screws, they will be used later to hold the blower cover plate.
PARTS BAG
blower cover plate (shaded part on illustration below) to the inner back of hood (see inset).
Remove the right cover plate remaining retaining screws (5 screws), then set the blower
cover along with its screws and nut aside.
remove it.
TAPE
TAPE
3
2
4
5
BACK OF HOOD
LOCK NUT
REMOVE
AND SAVE
THESE
SCREWS
S
CREWS REMOVED
4
IN STEP
1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nplec1 serie

Tabla de contenido