Installation; Recommended Tools And Accessories For Installation; Install Ductwork (Ducted Installations Only) - Broan EPLEC1 Serie Manual De Instalación, Uso Y Cuidado

Ocultar thumbs Ver también para EPLEC1 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

For ADA compliance installation guidelines, please visit www.broan-nutone.com
Recommended Tools and Accessories
for Installation
Measuring tape
Phillips screwdriver no. 2
Nut driver or socket 11/32"
Flat blade screwdriver (to open knockout holes)
Drill, 1/8" drill bit and 1½" hole saw (to mark holes for ducting and cut electrical access hole)
7/64" drill bit (to drill holes for EZ1 brackets mounting screws)
Wood shims (2) and wood screws (4) (required for standard installation to framed cabinet)
Saw (to cut holes for ducted application)
Sheet metal shears (ducted installation only, for duct adjustment)
Pliers (ducted installation only, for duct adjustment)
Metal foil duct tape (for ducted applications)
Scissors (to cut metal foil duct tape)
Pencil
Wire stripper
Strain relief, 1/2" diameter (to secure house wiring cable to the hood)

Install Ductwork (Ducted Installations Only)

18"
ABOVE COOKING SURFACE
NOTE: Distances over 24" are at the installer and user discretion.
1 ] Determine whether hood will discharge vertically (3¼" x 10" , 3¼" x 14" or 7" round),
or horizontally (3¼" x 10" or 3¼" x 14" only).
2 ] Decide where the ductwork will run between the hood and the outdoors.
3 ] Choose a straight, short duct run to allow the hood to perform most efficiently. Long duct
runs, elbows and transitions will reduce the performance of the hood. Use as few of them as
possible. When possible, use at least 2 foot straight runs before any turns. Larger ductwork
may be required for best performance with longer duct runs.
4 ] Install wall cap or roof cap (sold separately); ensure there is no leak in house insulation.
Connect metal ductwork to cap and work back towards the hood location. Use 2" metal foil
duct tape to seal the joints between ductwork sections.
R
OOF CAP
S
OFFIT
C
ABINET
H
OOD
- 24"
MIN
MAX
3¼"
10", 3¼"
14"
X
X
OR
7"
ROUND DUCT
(F
OR VERTICAL
)
DISCHARGE
H
OUSE WIRING
(T
)
OP OR BACK OF HOOD
W
ALL CAP
3¼"
10"
X
OR
3¼"
14"
X
DUCT
(F
)
OR HORIZONTAL DISCHARGE
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nplec1 serie

Tabla de contenido