Troubleshooting Guide - EINHELL GC-SC 18/28 Li Manual De Instrucciones Original

11. Troubleshooting guide

Fault
Motor does not start
Engine performance
drops
Imprecise scarifying
result
Motor stops sud-
denly
Anl_GC_SC_18_28_Li_Solo_SPK13.indb 27 Anl_GC_SC_18_28_Li_Solo_SPK13.indb 27
GB
Possible causes
a) Internal terminals disconnected
b) Safety lock-off defective
c) Scarifi er housing clogged
d) Safety plug is not connected
e) Battery is not correctly inserted
f) Battery is empty
a) Soil is too fi rm
b) Housing clogged
c) Roller badly worn
a) roller worn
b) Wrong working depth
a) Battery is overloaded
b) Battery is empty
- 27 -
Rectifi cation
a) By customer service workshop
b) By customer service workshop
c) Change the scarifying depth if
necessary; clean the housing so
that the spike drum can move freely
d) Connect safety plug (see 6.)
e) Remove battery and insert again
(see 5.)
f) Use a charged battery
a) Change working depth
b) Clean housing
c) Replace roller
a) Replace roller
b) Correct working depth
a) Switch the equipment off and on
again. If this happens often, use a
battery with higher capacity (Ah)
b) Use a charged battery
10.06.2021 14:07:57 10.06.2021 14:07:57