Advice On Disposal - UFESA AC2000 Manual De Instrucciones

2
Unplug the appliance.
3
Wind the cord by pressing the cord rewind button (1).
While doing this hold the cord to make sure it is not
tangled and the plug does not hit the vacuum cleaner
housing.
4
Disconnect the suction tube from the suction
nozzle or brush.
5
Disconnect the suction tube from the hose.
6
Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the
vacuum cleaner.
7
The vacuum cleaner may be stored in a vertical
position – just place the fastening hook of the
combination brush into the fastening of the combination
brush. The hose may be connected to the vacuum
cleaner. Yet it is necessary to make sure it is not bent to
hard during storing time.
Horizontal storage:
– place the fastening hook of the combination brush
into its fastening placed at the back of the vacuum
cleaner, near the cord exit.
Vertical storage:
– place the combination brush on the telescopic tube,
– place the fastening hook on the telescopic tube into
the fastening of the combination brush placed on
the bottom of the vacuum cleaner, near the front
wheel.
8
If necessary wipe the housing and the dust bag
container with a damp cloth (it may be soaked with
dishwashing liquid) and dry it or wipe until dry.
Do not use abrasive detergents or
solvents.
Examples of problems while operating
the vacuum cleaner
PROBLEM
The dust bag is
damaged.
The suction power
of the vacuum
cleaner is weak.
ACTION
Remove the dust bag and the
filters.
Replace the dust bag and
the filters, check the suction
tube, the hose and the nozzle
– remove the cause of the
clogging.
PROBLEM
The electrical
installation fuse
went out.
The vacuum
cleaner does
not operate; the
housing or the
cord is damaged.

Advice on disposal

Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
This product complies with EU Directive
2002/96/EC. The crossed wheelie bin
symbol shown on the appliance indicates that
when it comes to dispose of the product it
must not be included in with household refuse. It must
be taken to a special refuse collection point for electric
and electronic appliances or returned to the distributor
when purchasing a similar appliance. Under current
refuse disposal regulations, users who fail to take
discarded appliances to special refuse collection points
may be penalised. Correct disposal of discarded
appliances means that they can be recycled and
processed ecologically, helping the environment and
allowing materials used in the product to be reused.
For more information on available waste disposal
schemes contact your local refuse service or the shop
where the product was purchased. Manufacturers and
importers are responsible for ecological recycling,
processing and disposal of products, whether directly
or via a public system.
Your local town council can provide you with information
about how to dispose of obsolete appliances.
The manufacturer does not accept any liability for any damages
resulting from unintended use or improper handling.
The manufacturer reserves his rights to modify the product any
time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.
ACTION
Check if other appliances
are not plugged to the same
electrical circuit as the
vacuum cleaner. If the fuse
goes out repeatedly, return the
vacuum cleaner to a service
point.
Return the vacuum cleaner to
a service point.