Technical Parameters; Static Electricity - UFESA AC2000 Manual De Instrucciones

●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.

Technical parameters

The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 84 dB(A).

Static electricity

In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1
Cord rewind button
2
Suction power regulation lider
3 ON/OFF button
4
Combination brush fastening
5
Handle
6
Plug and cord
7
Outlet filter cover
8
Bag repletion indicato
9
Front cover handle
10 Suction hose
11 Inlet filter (installed in the vacuum cleaner)
12
"Microfilter" outlet filter (installed in the vacuum
cleaner)
13 Telescopic suction tube with a fastening hook
14
SAFBAG dust bag (1 item)
15
Holder of the bag
16
Crevice nozzle
17
Small nozzle
18
Small brush
19 Switchable combination brush
Preparing the vacuum cleaner
for operation
1
Press the side button on the end of the suction hose.
2
Place the end of the suction hose in the vacuum
cleaner. You should hear a distinctive click, if you do it
right.
3
Attach the other end of the hose (the handle) to
the suction tube.
4
Adjust the length of the telescopic suction tube by
sliding the slider according to the arrow and pull out/
pull the tube together.
5
Assemble the appropriate nozzle or brush to the
other end of the suction tube.
6
Use combination carpet & floor brush for vacuuming
both hard surfaces and carpets. To clean hard surfaces
– wooden floors, plastic floors, ceramic tiles etc. pull out
the brush by pressing the switch on the combination
brush according to the figure
when vacuuming carpets (set the switch in "
7
Pull the plug and cord (6) out of the vacuum cleaner.
While pulling out the cord, pay attention
A
to the yellow stripe which signals the
end of the cord. Further attempts (pulling
on cord) may result in damaging the cord.
8
Plug in the appliance.
Before operation make sure that the bag is installed in
the vacuum cleaner chamber and that inlet filter and
the outlet filter is installed in the appliance.
9
Switch on the vacuum cleaner by pressing the "on/
off" button (3).
10
The vacuum cleaner is equipped with an electronic
suction power controller. The power adjustment is done
by means of a slider. By shirting the slider in a given
direction, you decrease
. Retract the brush
").
or increase suction.
B