Nozzle Review; Nozzle Connection - Mi-T-M JOB PRO JP serie Manual Del Operador

Ocultar thumbs Ver también para JOB PRO JP serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION & PREPARATION

NOZZLE REVIEW:

Various nozzles may be quick-connected into the end of the wand to change the
spray pattern or use the detergent feature. When using Quick Connects (Q.C.),
be certain the connection is securely locked. If not, the high pressure water
may shoot the nozzle from the wand, causing severe injury or serious damage.
To determine spray fan, refer to the actual number stamped on the nozzle. The
first two digits indicate the spray fan in degrees, i.e.; 00=0", 15=15°, 25=25°.
1. The 0" nozzle (RED): This is a blasting nozzle. It delivers a very
concentrated stream of water. Be cautious when using the straight narrow
stream. It is not recommended for use on painted or wood surfaces, or items
attached with adhesive backings. Uses: Removing weeds from sidewalk
cracks, stubborn stains from concrete, masonry, aluminum and steel, caked
mud from equipment, and cleaning lawn mower undersides.
2. The 15° nozzle (YELLOW): This is a chiseling nozzle. The spray should
be directed at a 45° angle to the surface and used like a scraper to remove
paint, grease and dirt. Uses: Surface preparation (removing mildew stains
and paint chips).
3. The 25° nozzle (GREEN): This is a flushing nozzle. This pattern is best
suited for flushing dirt, mud, and grime. Uses: Wet sweeping leaves from
walks, curbs and driveways, cleaning stable floors, washing swimming pool
bottoms, degreasing engines.
4. The 65° nozzle (BLACK) (OPTION #AW-8400-0021): This is a low
pressure detergent application nozzle. This broad spray pattern distributes
solution over vast areas under low pressure. Uses: Detergent application,
misting or rinsing.

NOZZLE CONNECTION:

1. Be certain the trigger gun is locked in the "OFF" position. See WARNING,
left.
2. The nozzle assembly should be disconnected from the gun/wand assembly
at this by retracting the locking ring on the quick-connect fitting to remove
the nozzle.
Job Pro JP-Series Operator's Manual
QUICK-CONNECT FITTING
WARNING
RISK OF INJECTION CAUSING
SEVERE INJURY!
NEVER LOOK DIRECTLY AT THE
NOZZLE ORIFICE UNLESS IT
IS DISCONNECTED FROM THE
GUN/WAND ASSEMBLY!
CONNECTION OF Q.C. NOZZLES
QUICK-CONNECT (Q.C.)
WARNING
RISK OF SEVERE INJURY!
THE TRIGGER GUN SHOULD
ALWAYS BE LOCKED IN THE OFF
POSITION WHEN NOT IN USE!
11

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido