About Bluetooth Icons; Connection; To Switch The Bluetooth Signal Output Of This; Connecting A Cellular Phone - Sony MEX-BT3700U Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the device to be connected. This
unit is displayed as "XPLOD" on the device
to be connected.
DR-BT30Q
XPLOD
XXXXXXX
4
If Passcode* input is required on the
display of the device to be connected,
input "0000."
XXXX
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, the unit is ready for connection to the
device.
"
" flashes and then stays lit after pairing is
complete.
5
Set the Bluetooth device to connect to
this unit.
"
" or "
" appears when the connection is
made.
* Passcode may be called "passkey," "PIN code," "PIN
number" or "Password," etc., depending on the
device.
Note
Pairing standby mode is not released until the
connection is made.

About Bluetooth icons

The following icons are used by this unit.
lit:
Bluetooth signal on
flashing:
Pairing standby mode
off:
Bluetooth signal off
lit:
Connection successful
flashing:
Connecting
off:
No connection
lit:
Connection successful
flashing:
Connecting
off:
No connection

Connection

If pairing has already been achieved, start
operation from here.
To switch the Bluetooth signal
output of this unit to on
To use the Bluetooth function, switch the
Bluetooth signal output of this unit to on.
1
Input passcode.

Connecting a cellular phone

"0000"
1
2
Connecting the last-connected
cellular phone from this unit
1 Be sure that both this unit and the cellular
2 Press (SOURCE) repeatedly until "BT
3 Press
Note
While streaming Bluetooth audio, you cannot connect
from this unit to the cellular phone. Connect from the
cellular phone to this unit instead. A connecting noise
may be heard over playback sound.
Tip
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone's specification. If
this unit does not reconnect automatically, connect
manually.
Press and hold (BT) until "
(about 3 seconds).
Bluetooth signal is switched to on.
Be sure that both this unit and the
cellular phone are switched to
Bluetooth signal on.
Connect to this unit using the cellular
phone.
"
"appears when the connection is made.
phone are switched to Bluetooth signal on.
PHONE" appears.
(handsfree).
"
" flashes while the connection is being
made. And then "
" stays lit when the
connection is made.
" lights
17

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido