Luminance Brands Kathy Ireland Home SWEEP ECO CF275BS00 El Manual Del Propietario página 6

3. Ceiling Fan Assembly
3.3
Remove one of the three #6-32 x 3/8" Pan Head
Screw with Lockwasher from the Motor Assembly Hub
(Figure 3) .
Retain the #6-32 x 3/8" Pan Head Screw with
Lockwasher for future use .
Loosen the remaining two #6-32 x 3/8" Pan Head
Screws with Lockwashers (Figure 3) .
3.4
Place the 2-pin motor assembly connector through the
large center hole of the Lower Housing (Figure 4) .
Position the Lower Housing key hole slots onto the two
loosened screw heads .
Rotate the Lower Housing clockwise to engage the two
screws .
NOTE: Verify that the serrated washers are not
trapped between the Lower Housing and the Motor
Assembly Hub.
Reinstall the previously removed #6-32 x 3/8" Pan Head
Screw with Lockwasher (Figure 4) .
Retighten all three #6-32 x 3/8" Pan Head Screws with
Lockwashers to securely attach the Light Kit Housing
Assembly to the Motor Assembly Hub (Figure 4) .
A spare #6-32 x 3/8" Pan Head Screw with Lockwasher
is in the hardware bag, if needed .
Carefully turn the partially assembled ceiling fan
right side up and position the fan on the styrofoam in
preparation for additional assembly .
3.5
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 8" Downrod (Figure 5) .
Remove the Pin from the 8" Downrod, then remove the
Hanger Ball (Figure 5) .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .12 .
NOTE: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
(Continued)
LOOSEN TWO #6-32 x 3/8"
PAN HEAD SCREWS
W/LOCKWASHERS
Figure 3
LOWER
HOUSING
Figure 4
PIN
PHILLIPS HEAD SET SCREW
Figure 5
(LOOSENED)
6
REMOVE & RETAIN ONE
#6-32 x 3/8" PAN HEAD
SCREW W/LOCKWASHER
REINSTALL ONE #6-32 x 3/8"
PAN HEAD SCREW
W/LOCKWASHER
RETIGHTEN TWO
#6-32 x 3/8" PAN
HEAD SCREWS
W/LOCKWASHERS
GREEN GROUND WIRE
8" DOWNROD
HANGER BALL
ETL Model No.: CF275