Cassette Player; Listening To A Tape - Sony XR-C7300 Manual De Instrucciones

Cassette Player

Listening to a tape

1
Press (OPEN) and insert a cassette.
Playback starts automatically.
2
Close the front panel.
If a cassette is already inserted, to start
playback, press (SOURCE) repeatedly until
"FWD" or "REV" appears.
The side facing up is played.
The side facing down is played.
Tip
To change the tape's playback direction, press
(MODE) (*).
To
Stop playback
Eject the cassette
6
Press
(OFF)
6
Fast-winding the tape
During playback, push the SEEK/AMS
control up or down and hold.
Fast-forward
Rewind
To start playback during fast-forwarding or
rewinding, press (MODE) (*).
Locating a specific track
— Automatic Music Sensor (AMS)
During playback, push the SEEK/AMS
control up or down and release, for each
track you want to skip.
You can skip up to nine tracks at one time.
To locate
succeeding tracks
To locate
preceding tracks
Note
The AMS function may not work when:
— the blanks between tracks are shorter than
four seconds
— there is noise between tracks
— there are long sections of low volume or quiet
interludes.
Changing the display item
Each time you press (DSPL), the item changes
as follows:
z Tape playback
Frequency* Z
* While the ATA function is activated.
After you select the desired item, the display
will automatically change to the Motion
Display mode after a few seconds.
In the Motion Display mode, all the above
items are scrolled in the display one by one in
order.
Tip
The Motion Display mode can be turned off. (See
"Changing the sound and display settings" on
page 14.)
SEEK / AMS
SEEK / AMS
z Clock
7