Using The Rotary Commander - Sony XR-C7300 Manual De Instrucciones

Fm/mw/sw
Ocultar thumbs Ver también para XR-C7300:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
By pressing buttons
(the SOURCE and MODE buttons)
(SOURCE)
Each time you press (SOURCE), the
source changes as follows:
TUNER n CD* n MD* n TAPE
Pressing (MODE) changes the operation
in the following ways;
• Tape :
playback direction
• Tuner :
FM1 n FM2 n FM3 n MW n
SW1 n SW2
• CD unit* : CD1 n CD2 n ...
• MD unit* : MD1 n MD2 n ...
* If the corresponding optional equipment is
not connected, this item will not appear.
Tip
When the POWER SELECT switch is set to position
B, you can turn on this unit by pressing (SOURCE)
on the rotary commander.
12
By rotating the control
(the SEEK/AMS control)
Rotate the control and release it to:
•Locate the beginnings of tracks on the
tape. Rotate and hold the control
momentarily, then release it to fast-wind
the tape. To start playback while fast-
winding the tape, press (MODE).
(MODE)
•Locate a specific track on a disc. Rotate
and hold the control until you locate the
specific point in a track, then release it to
start playback.
•Tune in stations automatically. Rotate and
hold the control to find a specific station.
By pushing in and rotating the
control (the PRESET/DISC control)
Push in and rotate the control to:
•Receive the stations memorized on the
number buttons.
•Change the disc.
Other operations
Rotate the VOL control to
adjust the volume.
Press (ATT) to
attenuate the
sound.
Press (OFF) to turn
off the unit.

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Xr-c7300w

Tabla de contenido