Fein WSG20-180 Instrucciones De Uso página 19

OBJ_BUCH-0000000073-001.book Page 19 Wednesday, May 30, 2012 3:17 PM
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off (figure 8 – 9).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Switching on without lock-on function:
Press the safety lock and the On/Off switch
(I) at the same time.
Release the safety lock again.
Switching off:
Release the On/Off switch ().
The self-start lock prevents the angle grinder
from automatically restarting again, even after
a brief interruption of the power supply, e.g.,
from a pulled mains plug.
en
19