Makita EM408MP Manual De Instrucciones Originales página 9

Installing the protector (cutting tool
guard)
WARNING:
Do not use a cutting tool
without an appropriate protector at any
time.
WARNING:
Always use the cutting tool
with the correct combination of the protec-
tor. Otherwise contact with a cutting tool may
cause serious injury.
NOTICE:
Periodically tighten the bolts
on the protector. Tighten the right and left
bolts evenly so that the gap between the
clamp and the protector is constant.
Protector (universal type)
CAUTION:
Make sure to push in the
protector extension until it is fully inserted.
Otherwise the protector extension may fall and
result in personal injury.
CAUTION:
Be careful not to injure your-
self with the cutter mounted on the protec-
tor extension.
Fix the protector to the clamp with bolts.
2
► 1. Clamp 2. Protector
To install the protector extension, insert the pro-
tector extension to the protector and then snap
the clips on. Make sure that the tabs on the pro-
tector extension fit into the slots on the protector.
1
2
► 1. Protector (universal type) 2. Clip
3. Protector extension 4. Cutter (inside)
5. Slot 6. Tab
To remove the protector extension from the pro-
tector, unclasp the clips and pull the protector
extension out.
NOTE: The cutter on the protector extension
keeps the nylon cord best length for cutting.
Protector (narrow type)
1
CAUTION:
self with the cutter mounted on the protector.
Attach the protector to the clamp using bolts.
► 1. Clamp 2. Protector 3. Cutter
NOTE: The cutter on the protector keeps the
nylon cord best length for cutting.
9 ENGLISH
4
3
Be careful not to injure your-
2
3
5
2
6
1