Read And Follow Safety Instructions - Pentair PRO-SOURCE PS6-S02 Manual Del Propietário

Safety
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you
see this symbol on your pump or in this
manual, look for one of the following signal words
and be alert to the potential for personal injury.
warns about hazards that will cause
serious personal injury, death or major property
damage if ignored.
warns about hazards that can cause
serious personal injury, death or major property
damage if ignored.
warns about hazards that will or can
cause minor personal injury or property damage if
ignored.
The label NOTICE indicates special instructions
which are important but not related to hazards.
Carefully read and follow all safety instructions in
this manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
California Proposition 65 Warning
This product and related accessories
contain chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm.
TPS and TPSP series tanks are
identical to PS and PSP series
tanks except for color.
TPS and TPSP tanks are TAN.
PS and PSP tanks are BLUE.
All parts are the same.
RULES FOR SAFE
INSTALLATION AND
OPERATION
Read the Owner's Manual and Rules for Safe
Operation and Installation Instructions carefully.
Failure to follow these Rules and Instructions could
cause serious bodily injury and/or property damage.
Install system according to local codes.
Always test water from well for purity before using.
Check your local health department for testing
procedure.
Before installing or servicing your tank, BE SURE
pump electric power source is disconnected.
BE SURE your pump electrical circuit is properly
grounded.
Remove bleeder orifices, air volume controls or
other air charging devices in existing system.
Hazardous pressure. To prevent
possible serious or fatal injury and/or damage to
equipment, system pressure must be less than 100
pounds per square inch (PSI). Except for PSP50,
PSP62, PSP85, PSP119 where less than 125 PSI is
required. Failure to follow this instruction can result
in tank blowup. If system discharge pressure can
exceed listed pressures, install a relief valve capable
of passing the full pump volume at listed pressures.
Hazardous pressure. Read owner's
manual before attempting to install, operate, or
service this tank. To avoid possible equipment
failure, severe injury, and property damage, do not
allow pump, tank, or piping system to freeze.
2