Installation And Adjustment; Tools - Vermeiren Carpo 2 SE Manual De Instrucciones

1. Turn the key  to OFF and take it out.
2. Open the protecting flap of the charging socket.
3. Insert the plug of the charger into the charging socket of the scooter .
4. Insert the mains plug of the charger into the power socket. Switch the charger to ON (a few models
have no ON/OFF switch; with these the loading device starts operating automatically when you
insert the mains cable).
5. The charger now starts to charge and the LED (red and orange) will be lit, which indicates that it is
busy charging. While charging your scooter it is not possible to run, drive your scooter because the
immovable function will be activated.
6. Once the charging process is complete, the LED (orange) turns green, thereby indicating that
loading is complete. The charging duration is about 6 hours. To ensure optimum performance a 10-
hour charge is recommended. But we do not recommend a charging more than 24 consecutive
hours.
7. First switch off the charger (if there is no ON/OFF switch, pull out the mains plug).
8. Pull out the charger out the power socket.
9. Pull out the charger plug from the charging socket of the scooter. Your scooter is again ready for
use.

Charge your scooter's batteries strictly in accordance with the description above. If you charge
the batteries too early, they will gradually lose capacity, thus cutting your scooter's traveling
range.

The manufacturer shall decline all liability for damage caused by incorrect charging.

Use only genuine original batteries. We do not accept any liability for damage caused by using
batteries not supplied by us.

Do not expose the batteries to temperatures below -10° Celsius or above 50° Celsius.

If the batteries are opened, all liability of the manufacturer is voided as well as any claim.

After charging do not leave the charger socket plugged into the scooter, as this will cause a
power drain on the scooter and temporarily reduce its range.
If you decide not to use your scooter for a prolonged period, you must nevertheless recharge it
regularly to keep it in a running condition ready for immediate use.

If the batteries are not being used for a prolonged period, they will discharge slowly by
themselves (in-depth discharging). Then it becomes impossible to recharge them with the
supplied battery charger. When batteries are not in use, they must be recharged at least every
4 to 8 weeks (depending on the charge indicator).

Note that if you recharge the batteries too frequently, they will eventually lose their capacity
irretrievably.

Use only the supplied battery charger and no other charging equipment.

The manufacturer shall decline all liability for damage caused by improper charging.

In every case the charging cycle must not be interrupted. The battery charger has an indicator
showing you when the charging cycle has been completed.

Do not charge any other electrical equipment with your scooter's battery or battery charger.
3

Installation and adjustment

The instructions in this chapter are for the user and the specialist dealer.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility. A list of
Vermeiren facilities can be found on the last page.
L
WARNING: Risk of unsafe settings - Use only the settings described in this manual.
L
WARNING: Risk of tipping over - Variation allowed adjustments can still change the
stability of your scooter (tilt back or sideways).
3.1

Tools

To set up the scooter the following tools are needed:

Wrench set n° 13

Allen keyset n° 5
Page 19
Carpo 2 SE
2016-01