Installation And Adjustment; Tools; Manner Of Delivery; Adjusting The Steering Unit - Vermeiren Ceres 3 Manual De Instrucciones


In every case the charging cycle must not be interrupted. The battery charger has an indicator
showing you when the charging cycle has been completed.
3

Installation and adjustment

The instructions in this chapter are for the user and the specialist dealer.
The scooter has been designed to be adjusted with a minimum of replacements parts. There is no
need for extra stock of spare parts.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility. A list of
Vermeiren facilities can be found on the last page.
L
WARNING: Risk of unsafe settings - Use only the settings described in this manual.
L
WARNING: Risk of tipping over - Variation allowed adjustments can still change the
stability of your scooter (tilt back or sideways).
3.1

Tools

To set up the scooter tools are not needed.
3.2

Manner of delivery

The scooter shall be delivered with:

1 frame with armrests, steering unit, rear and front wheels

1 footplate

1 seat

Manual

Accessories

2 batteries, battery charger, motors
3.3

Adjusting the steering unit

The steering unit can be adjusted in to many different positions to suit each driver.
L
WARNING: Risk of injury - Never adjust the angle while you are driving.
L
WARNING: Risk of injury - Turn the scooter off before you adjust the angle of the steering
unit.
3.4

Adjusting the seat

L
WARNING: Risk of injury - Never perform adjustments while you are driving.
L
WARNING: Risk of injury - Make sure that the seat is locked securely.
Remove seat (Fig. A)

Pull the seat lever  upwards.
 
a little bit and lift the seat out the adjustment bar .
Turn the seat

Release the seat lever
1. Loosen the starknob.
2. Adjust the steering unit in the desired position.
3. Tighten the starknob to secure the steering unit.
.
Page 18
Ceres 3, Ceres 4
2015-03