Bosch 26614 Instrucciones De Funcionamiento Y Seguridad página 11

BM 2609140646 07-09:BM 2609140646 07-09 7/29/09 2:18 PM Page 11
MODE SELECTOR SWITCH
The selector switch allows the tool to be set
for various Drilling/Impact Driving applications.
The mode selector switch has three settings.
Speed 1 drill only: provides
slower speeds for drilling with large
diameter bits in wood, metal,
ceramics and plastic.
Speed 2 drill only: provides
faster speeds for drilling with small
diameter bits in wood, metal,
ceramics and plastic.
Driving with impact action:
Provides high torque and high
speed to drive screws, bolts, nuts
and other common fasteners.
Do not operate the selection
C UTION
switch until the tool comes
to a complete stop. Shifting during rotation of
the chuck can cause damage to the tool.
To change speeds slide switch to desired
setting (Fig. 4).
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when driving (Fig. 1).
BIT STORAGE AREA
Your tool is equipped with a bit and storage
area that is conveniently located in the handle
base where it is always handy and unlikely to
get lost or misplaced (Fig. 5).
BELT CLIP
When the tool is attached to
W RNING
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool
to fall resulting in injury to the operator or
bystanders.
The optional belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
To prevent damage to tool
C UTION
always check to make sure
the mode selector switch is fully engaged
into desired setting. If you have difficulty
fully engaging the switch, lightly squeeze and
release the trigger before pushing the switch
into desired setting.
FIG. 4
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig. 5).
To use clip, turn tool upside down and attach
to your belt.
-11-
FIG. 5
BIT ND BIT
STOR GE
RE
BELT CLIP