Bosch 26614 Instrucciones De Funcionamiento Y Seguridad página 10

BM 2609140646 07-09:BM 2609140646 07-09 7/29/09 2:18 PM Page 10
Disconnect battery pack
W RNING
from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
INSERTING AND REMOVING
ACCESSORIES
To avoid loss of control,
W RNING
ensure bit is locked in chuck
by pulling on bit after it has been inserted.
The chuck accepts only standard 1/4"
hexagonal shank accessories with power
groove.
Your tool is equipped with a quick release
chuck. To insert an accessory, simply pull
locking sleeve forward, insert desired
accessory into chuck and release locking
sleeve (Fig. 2).
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
C UTION
"OFF" position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 3). This lever was designed for
changing rotation of the bit, and for locking the
trigger in an "OFF" position.
For forward rotation, (with chuck pointed away
from you) move the lever to the far left.
Assembly
Operating Instructions
BRAKE
To remove an accessory, pull locking sleeve
forward and simply remove it from the chuck.
LOCKING SLEEVE
FIG. 2
HEX-SH NK
DRILL BIT
SCREWDRIVER
BIT
SCREWDRIVER BIT
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to the
center off position.
Do not change direction of
W RNING
rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to the
tool.
FORW RD/REVERSING
LEVER & TRIGGER LOCK
-10-
CHUCK
BIT HOLDER
FIG. 3