Approved Power Tool Attachments; Assembling The Unit - Stihl HL 94 Manual De Instrucciones

English
Approved Power Tool
Attachments
The following STIHL attachments may
be used with the basic power tool:
Attachment Application
1)
HL 0°, 500 mm Long reach hedge
trimmer
1)
HL 0°, 600 mm Long reach hedge
trimmer
HL 145°, Long reach hedge
1)
500 mm trimmer
HL 145°, Long reach hedge
1)
600 mm trimmer
2)
HT Pole saw
2) 3)
BF Cultivator with pick
tines
2) 3)
KB (4601) Bristle brush
2) 3)
KW (4601) PowerSweep
1)
Loop handle required on versions
with long drive tube (HL 94)
2)
Not approved for versions with
short drive tube (HL 94 K)
3)
Loop handle required
14

Assembling the Unit

Mounting the Loop Handle (HL 94)
Loop handle is required on versions with
long drive tube (HL 94).
7
8
2
3
5
6
9
Place the clamp (1) in the loop
N
handle (2) and position them both
against the drive tube (5) between
the carrying ring (3) and handle
hose (4).
Position the clamp (6) against the
N
shaft.
Line up the holes.
N
Insert the screws (7) with
N
washers (8).
Fit the square nuts (9) and screws.
N
7
8
Align the loop handle (2) and move
N
1
it to the most comfortable position
(recommended: about 20 cm/8 in).
Tighten down the screws firmly.
N
4
9
A
2
HL 94, HL 94 K