JVC KD-SX24BT Manual De Instrucciones página 19

BLUETOOTH®
BT MODE
PHONE SELECT* Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
AUDIO SELECT*
" " appears in front of the current playback audio device.
1 Turn the volume knob to select a device to delete, then press the
DEVICE DELETE
knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
PIN CODE EDIT Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press
Repeat steps
3 Press the volume knob to confirm.
RECONNECT ON: The unit automatically reconnect when the last connected
Bluetooth device is within range. ; OFF: Cancels.
AUTO PAIRING ON: The unit automatically pair supported Bluetooth device (iPhone/
iPod touch/Android device) when it is connected through USB input
terminal. Depending on the operating system of the connected device,
this function may not work. ; OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; NO: Cancels.
INFORMATION MY BT NAME: Displays the unit name ("KD-SX2 BT"). ;
MY ADDRESS: Shows address of this unit.
* You can only connect a maximum of two Bluetooth phones and one Bluetooth audio device
at any time.
to move the entry position.
1 2
and until you finish entering the PIN code.
Default: XX
Bluetooth compatibility check mode
You can check the connectivity of the supported profile between the
Bluetooth device and the unit.
• Make sure there is no Bluetooth device paired.
1
Press and hold
"BLUETOOTH"
PHONE" "PIN IS 0000" scrolls on the display.
2
Search and select "KD-SX2 BT" on the Bluetooth device within
3 minutes.
3
Perform (A), (B) or (C) depending on what appears on the display.
(A) "PAIRING"
passkey appears on the unit and Bluetooth device, then operate
the Bluetooth device to confirm the passkey.
(B) "PAIRING"
(C) "PAIRING": Operate the Bluetooth device to confirm pairing.
After pairing is successful, "PAIRING OK"
Bluetooth compatibility check starts.
If "CONNECT NOW USING PHONE" appears, operate the Bluetooth device
to allow phonebook access to continue.
"TESTING" flashes on the display.
The connectivity result flashes on the display.
"PAIRING OK" and/or "HANDS-FREE OK"*
and/or "PBAP OK"*
* 1
Compatible with Hands-Free Profile (HFP)
* 2
Compatible with Advanced Audio Distribution Profile (A2DP)
* 3
Compatible with Phonebook Access profile (PBAP)
After 30 seconds, "PAIRING DELETED" appears to indicate that pairing has
been deleted, and the unit exits check mode.
• To cancel, press and hold
on the power again.
.
"CHECK MODE" appears. "SEARCH NOW USING
"XXXXXX" (6-digit passkey): Ensure that the same
"PIN IS 0000": Enter "0000" on the Bluetooth device.
"[Device Name]" appears and
1 and/or "AUD.STREAM OK"*
3 : Compatible
to turn off the power, then turn
2
15
ENGLISH