Depth Adjustment - Bosch CS5 Instrucciones De Funcionamiento

BM 1619P06013 09-12_BM 1619P06013 09-12 9/17/12 8:25 AM Page 10

DEPTH ADjUSTMENT

Disconnect plug from power source. Loosen
the depth adjustment lever located in the
housing of saw. Hold the foot down with one
hand and raise or lower saw by the handle.
FIG. 3
FOOT
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0° on quadrant,
retighten lever and check for 90° angle
between the blade and bottom plane of foot
with a square (Fig. 5). Make adjustments by
turning the small alignment screw, if necessary.
BEVEL ADjUSTMENT
Disconnect plug from power source. The foot
can be adjusted up to 56° by loosening the
bevel adjustment lever at the front of the saw.
Align to desired angle on calibrated quadrant.
Then tighten bevel adjustment lever (Fig. 6).
Because of the increased amount of blade
engagement in the work and decreased
stability of the foot, blade binding may occur.
Keep the saw steady and the foot firmly on the
workpiece.
Operating Instructions
CALIBRATED DEPTH
BRACKET
DEPTH
ADJUSTMENT
LEVER
BLADE WRENCH
& STORAGE AREA
Tighten lever at the depth setting desired.
Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
FIG. 4
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
FIG. 5
BEVEL
90°
ADJUSTMENT
LEVER
FIG. 6
BEVEL
ADJUSTMENT
LEVER
QUADRANT
-10-
ALIGNMENT
SCREW
FOOT
BLADE