1. Install the 2 rollers (H) on the door panel (J). Use a ratchet to strongly tighten the bolts.
2. Insert the door bottom seal strip (O) onto the door panel (J).
3-4. Gently hang the door panel (J) by its 2 top rollers on the support bar (F) and make sure to place the
bottom of the door inside the guide (Q).
5. Install the 2 anti-jump pegs (I) on the door panel (J). Use a ratchet to strongly tighten the blots.
6. Drill the 2 wall tracks (B & B1) on 3 positions with a ø1/8" (3mm) drill bit.
1
H
J
3
J
F
5
I
J
DOOR PANEL INSTALLATION
CC
14
2
J
O
4
J
C
Q
6
&
B
B1
ø1/8"
3mm