Safety Instructions - Jøtul GF 3 BF2 Instrucciones Para Instalación

ENglish
Natural Gas G20: approx. 0,57 m 3 /hr
Gas consumption:
at full capacity. Natural Gas G25:
approx. 0,66 m 3 /hr at full capacity.
LPG approx. 0, 43 kg/hr at full
capacity.
Input effect kW: Natural gas G20/G25: 6,2 kW max
-
LPG: 6,2 kW max - 3,2 kW min.
Output nom. effect kW: Approx. 2,5 - 4,6 kW
Efficiency: Min. 77.%
Gas Jets (Orifices):
Main burner
Gas Labelled
G20 200
G25 235
G30 140
G31 140
Optional equipment: See point. 12.0

3.0 Safety instructions

Warning! If you detect an odour of gas:
• Shut off the gas to the premises.
• Open all windows and doors.
• Extinguish all naked flames.
• Do not light the stove or any other appliance.
• Do not use electrical switches or the telephone.
• Contact the fire department immediately from a neighbour's
telephone.
• The stove must only be installed and repaired by qualified
personnel.
• Always turn off the gas supply before service.
• The stove must be inspected following installation and at
least once a year by qualified personnel.
• The stove must only use gas of the correct type and pressure
See technical data for more details.
• The stove is pre-set for natural gas G20. If propane or butane is
to be used, the stove must to be converted with a conversion kit.
This is only to be installed by qualified personnel.
• It is permitted to install the stove against a wall made of
combustible material with the clearances specified in fig. 1.
• The stove must only be used if it is connected to a vent system
approved by Jøtul.
• The stove must only be installed indoors.
• The minimum clearance to combustible material in front of
the stove is 700 mm.
• Never store combustible gas or liquid in the same room with
the stove.
• The air regulator on the burner must only be adjusted by
qualified personnel.
• If any parts of the stove have been submerged in water,
contact qualified service personnel to replace these parts.
• Never light the stove without the front glass in place or if the
glass is cracked.
• Do not burn solid fuel in the stove.
• Do not place combustible material on or near the stove, as it
becomes very hot in use.
• Be aware that the stove becomes hot and make sure to keep
children and animals at a safe distance.
• A suitable fireguard must be used for young children the
elderly or infirm.
14
3,2 kW min.
Pilot burner
Labelled
51
51
30
30
3.1 Safety clearances
Min. distance from insert's heat shield to wall of flammable
material: See fig. 1.
Min. distance between furniture and the front of the fireplace:
700 mm.
Minimum clearances from combustible
material to vent system
Horizontal vent pipe:
From the top of the vent pipe to combustible material: 50mm
From the side and the bottom of the vent pipe to combustible
material:
Vertical vent pipe:
From all sides of the vent pipe to combustible material: 25mm
3.2 Clearances for position of flue vent
system
• Clearance under porch, covered entrance, story or balcony,
that have at least two open sides under the floor - 300 mm
• Clearance to window or door that can be opened -
300 mm
• Clearance to permanently closed window, recommended
clearance to avoid condensation on the window-300 mm
• Vertical clearance from vent to roof overhang -300 mm
• Clearance to exterior corner -230 mm
• Clearance to interior corner- minimum 150 mm
• Clearance surrounding gas meter/installed regulator in
horizontal direction from the centre of the regulator-900 mm
• Clearance to gas service cabinet with main shutoff valve - 900
mm
• Clearance to air channels or air supplies to all appliances-300 mm
• Clearance to mechanical air channel-1.8m
• Clearance from public walkway or motor road –2.1m
• Note! Do not install the vent over a walkway or motor road,
which is located between 2 individual family houses and is
used by both households.
3.3 Position of outdoor exhaust hood
For further information (vent system Ø 100/150 mm): see manual
for Balanced flue system.
• If the clearance from ground level to the terminal exhaust
hood is less than 3 m, the hood must be protected by a wire
mesh guard.
• The clearance over the terminal must be minimum 300 mm
to protruding parts of the building.
• Do not place the exhaust hood under any ventilation
opening,
• Do not place the exhaust hood closer than 300 mm from the
side/above any ventilation opening.
• Do not place the exhaust hood closer than 300 mm to opening
window.
• Clearance from ground level, balcony or similar to the exhaust
hood must be at least 300 mm.
• Do not place the gas cylinder closer to the exhaust hood than
1 metre.
25mm