Machine Usage - Garland SCAR FIRST E Manual De Instrucciones

English
6.7. CHECKING POINTS PRIOR TO USING THE
MACHINE
Check all the machine and make sure that there are
no loose parts (screws, nuts, knobs etc) and any
damages to the machine.
Tighten, repair or replace all necessary equipment
prior to using the machine.
Check the state of the catcher and that it is properly in
place. Do not use the machine if it is damaged or not
properly regulated.
6.8. START UP AND STOPPAGE
Do not place hands or feet under the scarifier.
Maintain all body parts well clear from all cutting
elements when the machine is in use. Before
starting the scarifier, check that the cutting blades are
not in contact with any object.
Start up of the machine:
Press the security button (2) and without letting go of
it, pull upwards the bottom switch On/Off (1). UOnce it
has started, let go of the security butto.
Stopping the machine:
Let go of the bottom switch On/Off.
1
2
After stopping the machine, the blade will not stop
inmediately. Wait until it has stopped before carrying
out any maintenance work on the machine or before
transporting the machine.

7. MACHINE USAGE

Use this machine only for jobs for which it has
been designed. The use of this machine for any other
jobs is dangerous and can cause dangers to the users
and/or to the machine.
Do not place hands or feet under the scarifier.
Maintain all body parts well clear from all cutting
elements when the machine is in use.
Before starting the scarifier, check that the cutting
blades are not in contact with any object.
Should you slip or fall, let go of the handle
immediately.
Do not rely solely on the security elements of the
machine, use your common sense.
Do not use this machine if fatigued, sick, if you have
had medicines, drugs or alcohol.
Do not use this machine at night, with fog or with
reduced visibility. You must be able to see and control
the working area.
Lack of sleep or fatigue can cause accidents and
damages.
Never leave the machine unattended.
Do not allow anybody to enter the working area. The
perimeter is no less than 15 metres and nobody
should enter this working area as it is a danger zone.
Clean the working area and remove any obstacles that
could cause accidents.
Always regulate the machine on a flat and stable
surface.
30/100