4. Initial use
The batteries are already inserted in all new devices. Before first use, remove the protruding plastic insulating strip from the
battery compartment. The thermometer will then switch on automatically.
Further information and FAQs available at: http://www.beurer.com
5. Setting the device
Set the unit for the temperature display as well as the date and the time.
8
8 8
88:88
When the thermometer is used for the first time and each time the batteries are changed, the date and time are displayed
(after the self test) in the basic setting (
the time. To set the device, proceed in stages: Unit – year – month – day – hours – minutes.
• Press the
button for approx. three seconds in order to reach Set mode.
The setting to be changed will flash each time.
• Press the
button again to save the setting or
• press the
button to change the setting.
• Then press the
button to save the setting.
After this process, the thermometer shows the word
6. What you should know about using this thermometer
There are different thermometers for taking temperature measurements in different parts of the body:
• Ear/forehead thermometer (this thermometer, for measuring in the ear or on the forehead area)
• Rod thermometer (for rectal [in the back passage], axillary [under the arm] or oral measurement [in the mouth])
Press the
button for 1 second to switch the thermometer on. The device performs a
brief self test: all elements of the display are shown for approx. 1 second. Following a
successful self test, the device emits two short beeps. In Standby mode, the date and
8
time are shown and "
). Now set the unit in which the temperature will be displayed, the date and
" is displayed.
in the display and switches off automatically.
21