DM 2610013190 04-12_DM 2610013190 04-12.qxp 4/10/12 8:05 AM Page 10
STANDARD FLAT WHEEL ASSEMBLy
Disconnect the plug from
WARNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
The Lock Bolt which attaches the cutting wheel
to the tool should be turned CLOCKWISE to
be loosened and COUNTERCLOCKWISE to
be tightened (Fig. 3). This bolt is reverse
threaded compared to standard threaded
fasteners.
The Dremel Saw-Max features two cutting
wheel positions- one position using a standard
flat wheel for all your typical straight and
plunge cuts (Fig. 4), and a second optional
wheel position for making flush cuts along
flooring or against a wall (Fig. 5).
Do not attempt to mount
WARNING
two cutting wheels onto the
tool at the same time.
SPINDLE LOCK
INNER
WASHER
FIG. 2
STANDARD
FLAT WHEEL
FIG. 4
Assembly
1. Turn LOCK BOLT with wrench provided
clockwise and remove LOCK BOLT and
OUTER WASHER (Fig. 2). If the shaft
moves while attempting to loosen the lock
bolt press the spindle lock (Fig. 2).
2. Slide wheel behind the guard face and
mount it against the INNER WASHER on
the shaft (Fig. 4).
3. Reinstall OUTER WASHER and tighten lock
bolt finger tight.
4. Press spindle lock to lock shaft and tighten
LOCK BOLT counter-clockwise until tight
with the wrench provided.
1. Repeat step 1 of above.
2. Place flush cutting wheel against the INNER
WASHER on the spindle shaft. (Fig. 5).
3. Reinstall OUTER WASHER and tighten
LOCK BOLT finger tight.
4. Press spindle lock to lock shaft and tighten
LOCK BOLT counter-clockwise until tight
with the wrench provided.
FLUSH CUTTING
WHEEL
(OPTIONAL)
OUTER WASHER
GUARD
FIG. 5
FACE
STANDARD WHEEL
-10-
FLUSH CUTTING WHEEL ASSEMBLy
GUARD FACE
LOOSEN
LOCK BOLT
LOCK
BOLT
WRENCH
FIG. 3
TIGHTEN
FLUSH
CUTTING WHEEL