Bestron ABL930SR Manual Del Usuario página 24

AcceSSorieS
This vacuum cleaner is supplied with one combined
accessory:
• a crevice tool with a narrow nozzle, which you
can use to clean radiators, window frames,
crevices, small openings, and similar;
• a dusting brush, which you can use
to clean delicate or irregular surfaces,
furniture, Venetian blinds, and similar.
oPerAtion - StorAGe AFter uSe
1. Remove the plug from the wall socket.
2. Press the rewind button and keep it pressed in;
the power cord will automatically rewind onto
the reel.
Guide the power cord whilst it rewinds onto the
reel, since otherwise the cord could become
tangled or the plug could strike the back of the
appliance. Take hold of the power cord near the
mark, and allow it to gently slide through your
fingers back into the appliance, see Figure 5.
3. An attachment slot for the accessory bracket
is fitted to the back. Slide the bottom of the
accessory bracket into the slot. This avoids the
need to dismantle the vacuum cleaner after
use; you can store the assembled appliance
and retrieve it again quickly when you need it.
cleAninG And mAintenAnce - cleaning the housing
1. Remove the plug from the wall socket.
2. Clean the outer surface of all parts with a damp cloth and a cleaner suitable for plastics.
3. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing the
wheels from turning easily. Consequently they should be kept clean.
• Never immerse the appliance, plug or power cord in water.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
cleAninG And mAintenAnce - removing waste from the dust container
1. Change the dust container immediately once the 'dust container full' indicator turns red (see Figure 1,
number 15).
It is possible that the indicator turns red whilst
the dust container is not yet full. If so, then the
nozzle, hose or tubes may be blocked. These
will then need to be cleaned.
2. Remove the plug from the wall socket.
3. Remove the hose.
4. Remove the dust container by pressing the
release button on the dust container (see figure
7A) and pulling on the container, and hold it
above a waste-bin.
A
24
instruction manual
B C