Stihl BT 45 Manual De Instrucciones página 12

English
WARNING
Before working with an ice auger
attachment on frozen ponds, lakes or
streams, check with local authorities and
take all necessary precautions to ensure
safe ice thickness.
WARNING
Thrown objects may ricochet and strike
the operator.
Operating Instructions
WARNING
Do not operate your power tool using the
starting throttle lock, as you do not have
control of the engine speed.
In the event of an emergency, switch off
the engine immediately – move the stop
switch to 0 or STOP.
WARNING
When taking the drilling tool out of the
hole, lift the machine vertically so that
the tool comes out straight without
canting. To minimize splashing when
drilling ice holes, back off the throttle
when the drilling tool breaks through the
ice. Raise the unit slowly. Cover and
clearly mark boreholes to prevent
anyone from stepping in a hole.
WARNING
To reduce the risk of injury from contact
with the drilling tool, always switch off
the engine and put the gear in the
neutral position N before changing a
10
drilling tool. For specific instructions to
change the drilling tool see the chapter
"Fitting the Drilling Tool."
WARNING
To reduce the risk of injury, never touch
a drilling tool or drilling spindle with your
hand or any part of your body. It
continues to rotate for a short period
after the throttle lever is released.
Always shut off the engine before putting
the machine down.
WARNING
Drilling tool blades and point are sharp.
To reduce the risk of cut injuries, use
caution when operating and handling.
MAINTENANCE, REPAIR AND
STORING
Maintenance, replacement, or repair of
the emission control devices and
systems may be performed by any
nonroad engine repair establishment or
individual. However, if you make a
warranty claim for a component which
has not been serviced or maintained
properly or if nonapproved replacement
parts were used, STIHL may deny
coverage.
WARNING
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non-STIHL parts may cause serious or
fatal injury.
Strictly follow the maintenance and
repair instructions in the appropriate
section of your instruction manual.
Please refer to the maintenance chart in
this manual.
WARNING
Always stop the engine and turn the
gear into the neutral position N before
doing any maintenance or repair work or
cleaning the power tool.
WARNING
Do not attempt any maintenance or
repair work not described in your
instruction manual. Have such work
performed by your STIHL servicing
dealer only.
WARNING
Never test the ignition system with the
spark plug boot removed from the spark
plug or with a removed spark plug, since
uncontained sparking may cause a fire.
WARNING
Use the specified spark plug and make
sure it and the ignition lead are always
clean and in good condition. Always
press spark plug boot snugly onto spark
plug terminal of the proper size. (Note: If
terminal has detachable SAE adapter
nut, it must be securely attached.) A
loose connection between spark plug
terminal and the ignition wire connector
in the boot may create arcing that could
ignite combustible fumes and cause a
fire.
BT 45