Fitting The Auger - Stihl BT 45 Manual De Instrucciones

WARNING
Do not change the position of the rotary
knob while the engine is running above
idle speed – the drilling tool rotates.
N Neutral: Gearbox in neutral for
starting, adjusting the carburetor
and changing the drilling tool.
1 Low-speed clockwise rotation, see
"Specifications"
2 High-speed clockwise rotation, see
"Specifications"
R Counterclockwise rotation, e.g. for
releasing a trapped drilling tool
BT 45

Fitting the Auger

With the engine stopped (knob in N
N
position), place the machine on the
ground and make sure it is secure.
Chuck for wood drills or twist drills
1
2
Insert the drilling tool (1) in the
N
chuck (2) and tighten it firmly.
WARNING
When using the geared rim drill chuck
(special accessory), make sure you
remove the chuck key before starting up.
Adapter for planting hole auger
5 3
4
Screw the adapter (3) onto the
N
drilling spindle (4).
Use a 13mm open-end wrench to
N
hold the spindle steady and tighten
the adapter firmly with a 19mm
open-end wrench.
Secure the drilling tool (5) in the
N
adapter.
Use a 17mm open-end wrench to
N
secure and release the planting
hole auger.
English
19