Gearbox - Stihl BT 45 Manual De Instrucciones

English
Filler cap is now closed.
If the filler cap will not engage into the
tank housing
The base of the filler cap is rotated in
relation to the upper part.
Look at the black alignment marks
N
on the top of the filler cap.
1
Left: Base of filler cap is rotated –
interior marking (1) is aligned
with the exterior marking.
Right: Base of filler cap is in the cor-
rect position – interior
marking is below the clip. It
does not align with the exte-
rior marking.
18
With the filler cap in the filling neck,
N
twist it counterclockwise until it
drops into its seat.
Continue to twist the filler cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position.
While pushing down on the cap,
N
twist the filler cap clockwise and
close it – see section "Closing."

Gearbox

The power drill is equipped with a
change-speed gearbox. Depending on
the application and the drilling tool used,
the speed can be adjusted to suit
requirements.
Knob positions
NOTICE
The position of the rotary knob may be
changed only when the engine is
running at idle speed – the drilling
spindle must be stationary. It may be
necessary to turn the drilling spindle
slightly before the rotary knob can be
moved to the required position.
BT 45