Know Your Product; Operation - SPARKY PM 2030 Instrucciones De Uso

sanding paper. Larger sanding paper ex-
tending beyond the sanding pad presents
a laceration hazard and may cause snag-
ging, tearing of the disc or kickback.
Safety Warnings Specific for Polishing
Operations:
a) Do not allow any loose portion of the
polishing bonnet or its attachment
strings to spin freely. Tuck away or trim
any loose attachment strings. Loose and
spinning attachment strings can entangle
your fingers or snag on the workpiece.
Safety Warnings Specific for Wire
Brushing Operations:
a) Be aware that wire bristles are thrown
by the brush even during ordinary op-
eration. Do not overstress the wires by ap-
plying excessive load to the brush. The wire
bristles can easily penetrate light clothing
and/or skin.
b) If the use of a guard is recommended for
wire brushing, do not allow any interfer-
ence of the wire wheel or brush with the
guard. Wire wheel or brush may expand in
diameter due to work load and centrifugal
forces.

Know your product

Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Spindle
2. Flexible backing pad
3. Lock nut
4. Auxiliary handle
5. ON/OFF switch
6. ON/OFF switch locking button
7. Spindle lock button
8. Sandpaper disc
9. Thumbwheel for electronic speed
preselection (РМB 2030Е, PMB 2230E,
PMB 2430E)
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
Wire brush;
Sandpaper Ø180mm;
Polishing bonnet (РМB 2030Е, PMB 2230E,
PMB 2430E)
Original instructions

Operation

These power tools are supplied from single-
phase alternating current mains only. They are
double insulated according to EN 60745-1,
IEC 60745-1 and can be connected to grounded
or not grounded sockets. This power tool is radio
suppressed in compliance with EMC Directive.
This power tool is designed for rough and fine
dry grinding, refurbishing and brushing, polish-
ing and rubbing all kinds of surfaces at optimum
chosen rotation speed.
PRIOR TO INITIAL OPERATION
▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ In case the work area is remote from the pow-
er source, use as short as practicable exten-
sion cord with proper cross-section.
▪ Check that the auxiliary handle is properly
mounted and reliably tightened.
SWITCHING ON - SWITCHING Off
The polisher is secured against unintentional
switching on.
Switching on: First press the auxiliary button 6
at the front of the switch lever; and then - press
the switch 5.
Switching off: Release switch 5.
SELECTION Of RPM VALUE
(РМB 2030Е, PMB 2230E, PMB 2430E)
Preselect the speed with thumbwheel 9, acc.
Table 1.
7
EN